Latest CompTIA N10-007 Exam Questions For Free – (July-2018 dumps)

Passing CompTIA Network+ N10-007 exam with overnight preparation is not hard if you get both practice test software and PDF files preparation products with money back guarantee. CompTIA Network+ N10-007 exam Practice test software is a simulation like real N10-007 exam however PDF files provide the latest N10-007 exam questions very similar to the pattern of real N10-007 exam questions. Make MacAfee Secure transaction to get these N10-007 exam questions with money back guarantee.

Vendor CompTIA
Exam Code N10-007
Full Exam Name CompTIA Network+
Certification Name CompTIA Network+
Technology Application Networking

♥ 2018 Valid N10-007 Exam Questions ♥

N10-007 exam questions, N10-007 PDF dumps; N10-007 exam dumps:: https://www.dumpsschool.com/N10-007-exam-dumps.html (404 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate CompTIA N10-007 Dumps Exam Questions and Answers:

Question: 21

A network technician receives the following alert from a network device:
“High utilizations threshold exceeded on gi1/0/24 : current value 9413587.54”
Which of the following is being monitored to trigger the alarm?

A. Speed and duplex mismatch
B. Wireless channel utilization
C. Network device CPU
D. Network device memory
E. Interface link status

Answer: E

Explanation:
This is an error message that indicates that threshold of high utilization of network interface, in this case interfacegi1/0/24, has been exceeded. The message has been triggered on the interface link status.
Note: gi1/0 would be a gigabyte interface.

Question: 22

The administrator’s network has OSPF for the internal routing protocol. One port going out to the Internet is congested. The data is going out to the Internet, but queues up before sending. Which of the following would resolve this issue?
Output:
Fast Ethernet 0 is up, line protocol is up
Int ip address is 10.20.130.5/25
MTU 1500 bytes, BW10000 kbit, DLY 100 usec
Reliability 255/255, Tx load 1/255, Rx load 1/255
Encapsulation ospf, loopback not set
Keep alive 10
Half duplex, 100Mb/s, 100 Base Tx/Fx
Received 1052993 broadcasts
0 input errors
983881 packets output, 768588 bytes
0 output errors, 0 collisions, 0 resets

A. Set the loopback address
B. Change the IP address
C. Change the slash notation
D. Change duplex to full

Answer: D

Question: 23

Which of the following network devices use ACLs to prevent unauthorized access into company systems?

A. IDS
B. Firewall
C. Content filter
D. Load balancer

Answer: B

Explanation:
A firewall is a system designed to prevent unauthorized access to or from a private network. Firewalls arefrequently used to prevent unauthorized Internet users from accessing privatenetworks connected to the Internet, especially intranets. Firewalls use ACLs (access control lists) to determine which traffic is allowed through the firewall. All traffic entering or leaving the intranet passes through the firewall, which examines each message and blocks or allows the message depending on rules specified in the ACL. The rules in the ACL specify which combinations of source IP address, destination address in IP port numbers are allowed.

Question: 24

Which of the following is used to define how much bandwidth can be used by various protocols on the network?

A. Traffic shaping
B. High availability
C. Load balancing
D. Fault tolerance

Answer: A

Explanation:
If a network connection becomes saturated to the point where there is a significant level of contention, network latency can rise substantially.
Traffic shaping is used to control the bandwidth used by network traffic. In a corporate environment, business-related traffic may be given priority over other traffic. Traffic can be prioritized based on the ports used by the application sending the traffic. Delayed traffic is stored in a buffer until the higher priority traffic has been sent.

Question: 25

Which of the following is used to authenticate remote workers who connect from offsite? (Select TWO).

A. OSPF
B. VTP trunking
C. Virtual PBX
D. RADIUS
E. 802.1x

Answer: D,E

Explanation:
D: A RADIUS (Remote Authentication Dial-in User Service)server is a server with a database of user accounts and passwords used as a central authentication database for users requiring network access. RADIUS servers are commonly used by ISP’s to authenticate their customer’s Internet connections.
Remote users connect to one or more Remote Access Servers. The remote access servers then forward the authentication requests to the central RADIUS server.
E: 802.1X is an IEEE Standard for Port-based Network Access Control (PNAC). It provides an authentication mechanism to devices wishing to attach to a network.
802.1X authentication involves three parties: a supplicant, an authenticator, and an authentication server. The supplicant is a client that wishes to attach to the network. The authenticator is a network device,such as an Ethernet switch, wireless access point or in this case, a remote access server and the authentication server is the RADIUS server.

Question: 26

Which of the following provides accounting, authorization, and authentication via a centralized privileged database, as well as, challenge/response and password encryption?

A. Multifactor authentication
B. ISAKMP
C. TACACS+
D. Network access control

Answer: C

New Updated N10-007 Exam Questions N10-007 PDF dumps N10-007 practice exam dumps: https://www.dumpsschool.com/N10-007-exam-dumps.html

         

Facebook Comments