Latest Dell DNDNS-200 Exam Questions For Free – (March-2018 dumps)

Passing Dell Certified Professional DNDNS-200 exam with overnight preparation is not hard if you get both practice test software and PDF files preparation products with money back guarantee. Dell Networking Professional DNDNS-200 exam Practice test software is a simulation like real DNDNS-200 exam however PDF files provide the latest DNDNS-200 exam questions very similar to the pattern of real DNDNS-200 exam questions. Make MacAfee Secure transaction to get these DNDNS-200 exam questions with money back guarantee.

♥ VALID DNDNS-200 Exam Questions 2018 ♥

DNDNS-200 exam questions, DNDNS-200 PDF dumps; DNDNS-200 exam dumps:: (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest Dell DNDNS-200 Dumps Exam Questions and Answers:

Version: 8.0
Question: 21

Refer to the exhibits.
An organization has a network with the following configuration:
* 2x C-Series chassis in a VLT
* Identical 10Gb line cards in each C-Series chassis
* A Hyper-V Server directly connected to Te 0/1 on each C-Series chassis
* A VLT Port-Channel connected to a two port switch independent team on the server used for vSwitch Virtual Machine traffic
The Server Admin reports connectivity issues to the VMs on the server.
* Virtual Machines cannot ping outside of the local Server and cannot be reached from the LAN.
* All Virtual Machines are connected to the same vSwitch.
* All Virtual Machines are able to ping each other internally.
* All Virtual Machines are tagged in VLAN 10.
* All Nics on the Hyper-V Server are up.
What is causing the ping loss?

A. VLANs are configured incorrectly between the VLT peers.
B. LACP is not configured on the server.
C. One of the VLT peers is using a lower bandwidth transceiver.
D. LACP is configured as passive in the VLT domain.

Answer: B

Question: 22

Refer to the exhibit.
On switch S4820-2, commands are entered. The associated output is a follows:

Which command MUST have been entered previously on switch S4820-1?

A. S4820-1 (conf-pvst)#vlan 2 bridge-priority 4096
B. S4820-2 (conf-pvst)#vlan 2 bridge-priority 20480
C. S4820-1 (conf-pvst)#vlan 3 bridge-priority 20480
D. S4820-1 (conf-pvst)#vlan 3 bridge-priority 4096

Answer: A

Question: 23

Refer to the exhibit.
A network engineer is called onsite to troubleshoot replication failure and traffic loss. Whenever replication occurs between SAN A and SAN B, users report traffic loss between sites, and replication ultimately fails due to traffic loss.
Based on the topology shown, what is the most likely cause of the traffic loss?

A. Traffic needs to be policed on the site border routers.
B. An inbound policy map needs to be defined on the site border that marks the replication traffic with a DSCP value of 46.
C. An outbound policy map needs to be defined on the site border that marks the replication traffic with a DSCP value of 46.
D. Traffic needs to be shaped on the site border routers.

Answer: C

In Quality of Service, DSCP value 46 is high-priority traffic.

Question: 24

Refer to the exhibit of the N-series switches.
The exhibit shows a Layer 2 network between Host A (a Desktop Computer running Windows 7) and Host B (another Desktop Computer running Windows 7) and the list of VLANs Untagged (U) and Tagged (T) at each Ethernet interface: Host A transmits an Ethernet frame untagged on VLAN 1.
What will happen to the Ethernet frame?

A. SW2 drops the Ethernet frame when trying to transmit it out of interface E2 because the incoming and outgoing interfaces are Tagging/Untagging VLAN 1 differently.
B. The Ethernet frame is successfully delivered to Host.
C. STP drops the Ethernet frame because it cannot create an end-to-end loop free path between the switches for VLAN 1.
D. VLAN consistency protocol determines that the VLAN is not correctly Tagged/Untagged on all interfaces, an error will occur, and SW1 will drop the frame on interface E2.

Answer: B

Question: 25

Refer to the exhibit.
Considering the network topology and information shown, what is an issue with end point devices in network that try to route to

A. ICMP Redirects
B. Suboptimal Routing
C. Routing Loop
D. Summarization Black Hole

Answer: C

Question: 26

Refer to the Exhibit.
A network engineer receives the output shown when removing MLAG from a pair of N-Series switches.
Which sequence of steps must the engineer complete to remove the vpc peer-link from Port Channel 1?

A. Shut down the Port Channel interfaceIssue the no vpc peer-link command on the Port Channel
B. Remove the vpc feature using the no feature vpc commandIssue the no vpc peer-link command on the Port Channel
C. Remove the channel-group command from all members of the Port ChannelIssue the no vpc peer-link command on the Port Channel
D. Remove peer-keepalive enable using the no peer-keepalive enable commandIssue the no vpc peer-link command on the Port Channel

Answer: D

New Updated DNDNS-200 Exam Questions DNDNS-200 PDF dumps DNDNS-200 practice exam dumps:


Facebook Comments